If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have hunted everywhere I can think to look for the "End Mode" button to finish linking, but cant seem to find it. The only solution I've found so far is to log out and then log back in.
use "Close Linking" to set a end-point for the initiated link, this completes the linking process and connects two chosen objects. To Cancel the linking operation, use the "Cancel" button, which is the fourth.
Tweet
Can't find End Mode...
Comment